Test & Measurement Equipment Accessories
RF and microwave test accessories simplify test setups and give you the best possible measurement results.
An attenuator is an electronic device that reduces the power of a signal without appreciably distorting its waveform. An attenuator is effectively the opposite of an amplifier, though the two work by different methods. An RF switch or microwave switch is a device to route high frequency signals through transmission paths.Find out more about Attenuators
A calibration kit contains a set of physical devices called standards. Each standard has a precisely known or predictable magnitude and phase response as a function of frequency.Find out more about Calibration Kits
A coaxial RF connector (radio frequency connector) is an electrical connector designed to work at radio frequencies in the multi-megahertz range. RF connectors are typically used with coaxial cables and are designed to maintain the shielding that the coaxial design offers.Find out more about Coaxial Adaptors
RF Phase Shifters are used to change the transmission phase angle of an input signal. Ideally phase shifters provide an output signal with an equal amplitude to the input signal, any loss here will be accounted to the insertion loss of the component.Find out more about Phase Shifters
Incorporating a switch into a switch matrix system enables you to route signals from multiple instruments to single or multiple DUTs. This allows multiple tests to be performed with the same setup, eliminating the need for frequent connects and disconnects.Find out more about Switches
Termination loads are connected as a load to an open signal output or an RF line in order to avoid reflection. Termination loads are used for example on open ports on transmitters as well as in the calibration of RF test equipment.Find out more about Terminations